Firmware Download

Download the old version

Download Type Firmware
Model name IC-7410
Version Release 1
Update Aug.08.2013
Major changes

Improvements

  1. Fixed an audio problem when switching the band while receiving in the FM mode.

 

  • A USB cable is required. (A-B type, purchase separately) The firmware is updated through the USB port on the rear panel of the IC-7410.
  • The USB driver must be installed before connecting the USB cable between the IC-7410 and to the PC.
  • Please read "Firmware update instructions" thoroughly and make sure what is required for the firmware update.
  • Never turn OFF the transceiver power or disconnect the USB cable while the update is being performed.
  • Never connect anything, not even a cable, to the REMOTE jack, otherwise the firmware update may fail.
  • If you connect two or more IC-7410s to the PC, turn the power ON for only the one that you want to update as the update tool works on only one transceiver at a time.
Note
File Size 835KB
File Type zip

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.